![]() You can note that next to each strip, you have 8 buttons. Select the Primary output of your choice (In this case, I'm gonna select my headphones).You can click any strip you want, A1 A2 or A3. Voicemeeter Setupįirst of all, as you might have noticed: The software is asking us for a hardware output, you can note this by the blinking red "Select Main Output Device" on the top right of the app. This allows you to stream your desktop audio and talk while in a call, without your partners hearing themselves. Hardware input 1 (microphone) -> A2 Hardware out (CABLE input).The goal is being able to mix your microphone and desktop audio into a single track, while leaving Discord out of the equation. Both methods work, but the signal is "echoing", here is an example: So my idea was to monitor the input signal by routing it to the VB-cable, setting the output volume lower and then monitoring and routing it to the main output either in Voicemeeter Banana or in Windows control panel (via "Listen to this device"). I wanted to achieve this with Voicemeeter Banana, because Potato simply can't fit my laptop screen I've found this topic where the similar solution for another problem is discussed: viewtopic.php?t=683 This monitoring signal should have much lower level when the output of the VOIP app. I have ZOOM H1 for which I want to monitor the input, when I use it with a VOIP app and headphones.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |